5. The Hiking Kit
The assembled hiker (base + hiking kit) – example Cougar1
5.1 Fitting the Hiking Kit:
Parts supplied:
Drawbar with shoulder strap.
Push the short end of the drawbar into the attachment bracket. Once the holes of the attachment bracket and the draw- bar are aligned with each other (the end of the drawbar is visible), push the secu- ring pin from below through bracket and drawbar and lock it by pushing the clip over the pin.
The shoulder strap, which is attached in a similar way to that of a rucksack, can be adjusted in three positions: at the chest strap at the front,
The holes in the drawbars are larger than the safety snap pins, so that the drawbars can turn slightly around their longitudinal axis (in order to adapt to narrow or wide hips).
at the back strap on top for adjusting the height of the hip strap
and at the hip strap itself.
5.2 Safety Instructions for the Hiking Kit
(see also section 8 "General Safety Instructions”):
•Always make sure that the safety snap pin is fully pushed in and secure, so as to prevent the transporter from accidentally rolling.
25