Final steps in assembly:
At the clamp, pull tight the strap hol- | Pull tight the looped strap. |
ding the tops of both side walls toget- |
|
her, at the same time as applying pres- |
|
sure with the other hand from the out- |
|
side. |
|
Pull the 4 rear seat
The "Captain XL" is now ready for sale, and from now on, any further folding or opening of the bicycle trailer will not ent- ail reversal of the above steps.
1.1.2.2 Assembling and folding the compartment following initial operation
For assembling and folding the "Captain XL" in the same way as with the Cabriolet, Corsaire XL and Comfort, see sections 1.1.1 and 1.3.1
1.1.3 Assembling the passenger compartment of the Cheetah, Cougar and CX
Assembling the base: Push the hollow axle with your left hand downwards, and at | |
the same time push the left frame tube upwards using your right hand. Then pull |
|
the short curved tube backwards with your left hand, pressing against it from |
|
above with your right hand. Repeat this on the right hand side. When pulling the |
|
short, curved frame tube backwards, the |
|
1.1.4 Wheel assembly (plastic wheels) on the Cabriolet and Comfort
Put the passenger compartment on its side. Insert clevis axle into the opening of the hollow axle.
Push the wheel axle in as far as it will go. As you do this, the securing peg of the hollow axle must audibly engage in the axle groove of the wheel. Check that the wheel cannot be pulled off!
Removing the wheel: With one hand pull the securing peg outwards, with the other pull the wheel out of the hollow axle.
6