4. The Buggy Kit
The assembled buggy (base + buggy kit) – example Cougar1
4.1 Fitting the Buggy Kit:
Parts supplied: Buggy twin wheels
Unscrew the star knob of the buggy wheel and insert the wheel bolt from below through the large hole in the hitch arm attachment bracket.
Screw the star knob onto the threaded area of the wheel bolt and tighten securely. Repeat this on the other side. The star knob has a plastic thread.
protector, this means the wheel bolt is to be held tightly when turning off the star knob.
When fitting the star knob all that is needed is that the buggy wheel be pressed hard on the ground by apply- ing pressure on the hitch arm attach- ment bracket. Repeat this on the other side.
Safety Recommendation:
When using the carrier as a buggy always put the wrist strap, which is fastened securely on the left rear frame tube, around your wrist (see illustration for jogging kit).
If you wish to use your Chariot CTS in any other form than a buggy, it is very easy to take the buggy wheels with you. Simply insert them upside down into the hitch arm attachment bracket and secure them from below using the star knobs. The fork arms need to point forwards.
The star knob has a plastic thread pro- tector, this means the wheel bolt is to be held tightly when tightening up the star knob. When fitting the star knob all that is needed is that lateral pressure be applied to the buggy wheel so as to slightly twist the axle.
The fork of the buggy twin wheel must sit in both guide grooves of the hitch arm attachment bracket so that it can- not be turned.
23