Fisher-Price 76950 owner manual One time assembly is now complete. Do not assemble

	Assembly
21	23
T-Slider
	Grooves	Footrest	Footrest
		Support	Support
		Bar
	Footrest

Please Note: If you have not removed the protective foam	• Insert the footrest support bar through the footrest
pocket from the battery compartment, please remove it
and set it aside for later use. Remove any excess tape	support at the bottom of the vehicle body. Make sure the
from the vehicle and protective foam pocket and discard of	grooves on the footrest face up.
the tape properly.	• Align the holes in the other footrest with the holes on the
• Stand the vehicle body on its rear wheels.	other side of the footrest support and repeat assembly
• Align the holes in the T-slider with the holes in the	step 22 on the other side of the footrest support.
underside of the vehicle body, directly under the battery	24
compartment.
• Insert three #8 x 1/2" screws through the floor of the bat-		Footrest
tery compartment and into the T-slider.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Position the vehicle body upright.
22 Holes
Footrest
Support Bar
Footrest
Hole	• Turn the vehicle body on its side.
	• Using a Phillips screwdriver to steady the screw and
	pliers to grip the lock nut, continue to tighten the bolt and
	lock nut on each footrest.
	• Turn the vehicle body upright.
	One time assembly is now complete. Do not assemble
• Align the holes in a footrest with the holes in one end of	the seat until after you have charged and installed
	the battery in the vehicle. Please refer to the Battery
the footrest support bar.
	Installation section beginning on page 16 for
• Insert a #10 x 11/4" bolt through the footrest and footrest
	instructions.
support bar.

• Fit a lock nut onto the end of the bolt and hand-	14
tighten it.