Fisher-Price 76950 owner manual Good Fuse Blown Fuse

Page 8

Battery Charging

Your new battery must be charged for at least

18 hours before you use it in your vehicle for the first time.

We recommend that you start charging your battery before beginning assembly of your new vehicle.

The battery must be upright while charging.

Do not short circuit the battery.

You do not need to remove the battery from your vehicle to recharge it.

Use only a Power Wheels® 6 volt charger (120 VAC

60 Hz 6W with an output of 6 VDC (400mA) to charge your Power Wheels® 6 volt (4 Amp/hr.) battery.

1

25 Amp Fuse

 

GOOD FUSE

BLOWN FUSE

3

• Plug the charger into a standard 120 volt wall outlet.

Note: If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.

Before first time use, charge the battery for at least 18 hours. Never charge the battery longer than 30 hours.

Note: The battery must be upright while charging.

If you are charging the battery for the first time, insert a 25 amp fuse into the battery. The battery will not charge unless a 25 amp fuse in good condition is installed.

If you are recharging your battery, make sure the 25 amp fuse already installed in the battery is in good condition. Use pliers to remove the fuse from the battery. Look at the fuse to make sure it has not blown. Replace a blown fuse with a new Power Wheels® 25 amp fuse.

2

Charger

 

Charger

 

Connector

 

 

Battery

 

Connector

Recharge the battery after each use of your vehicle for at least 18 hours. Do not charge the battery longer than 30 hours.

Once the battery is charged, disconnect the charger connector from the battery connector. Unplug the charg- er from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the Battery Installation section on page 16 for detailed instructions on installing your battery. If your battery is already installed in your vehicle, simply re-connect the battery connector and motor harness connector and re-as- semble the seat to the vehicle. Always remember to lock the seat using the lock fastener or bolt to prevent chil- dren from accessing the battery.

CAUTION

Use the charger indoors only.

• Plug the battery connector into the charger connector.

IMPORTANT NOTE! If you are recharging your battery, you will first need to disconnect the battery connector from the motor harness connector under the seat of your vehicle.

8

Image 8
Contents Product features may vary from the picture above Table of Contents Important InformationPage Parts Parts Parts Diagram 101Battery Charging Good Fuse Blown Fuse Assembly Do Not Omit Any StepsHandlebar console Press Here Assembly Fit it under the handlebar assembly. The grille may One time assembly is now complete. Do not assemble Label Decoration Battery Installation Seat Requiring Use Locked Battery Care Battery Care DisposalDisposal RulesTeach Safety Rules to Children Rules for Safe DrivingAttaching Your Vehicle to the Base Removing Your Vehicle from the Base How to Operate Your Vehicle Exciting Kiddie Ride ActionFor Your Vehicle How to Operate Your Vehicle How to Operate Your VehicleCaring Problems and Solutions Guide Problem Possible Cause SolutionProblems and Solutions Guide Problems and Solutions Guide Statement of Limited Warranty Authorized Service CentersIdaho Montana Oregon Do Not Return Your Vehicle to the Store