BOB AA000001 manual Attach Main BAR

Page 2

ATTACH MAIN BAR

SET PARKING BRAKE. See the “Parking Brake” section of your stroller owner’s manual.

POSITION ARMS	ASSEMBLE SCREW, PLUG AND BAR
Rotate arms into an	Insert one pivot screw through one end of main bar
upright position.	and into pivot plug.
	Pivot Plug
	Pivot Screw
	Main Bar

POSITION ICSA

Holding pivot screw and pivot plug in place with hand, position ends of main bar over pivot brackets.

INSERT PIVOT PLUG

ON OPPOSITE SIDE

Slip pivot plug	Pivot
under end of	Bracket
main bar and
into opening on
pivot bracket.

INSERT PIVOT

PLUG AND SCREW

Slip pivot plug into	Pivot
opening on pivot	Bracket
bracket and push
pivot screw flush
against bar.

INSERT PIVOT SCREW

Insert pivot screw	Pivot
through main bar,	Bracket
pivot plug and into
opening on pivot
bracket.

INSTALL PIVOT NUT

Reach under fabric seat.

Thread pivot nut onto pivot screw as shown.

TIGHTEN PIVOT NUT

Use a Phillips screwdriver to tighten pivot screw clockwise, while holding pivot nut.

REPEAT STEPS 8 AND 9 FOR OTHER SIDE.

OMA09D

P2

Image 2

Contents Accessory Bar Infant Car Seat Adapter InstructionsAttach Main BAR Attach Restraint Belt M/F and Arms Attach Restraint Belt MBuckle Belt Position ARM Prepare Stroller for Infant CAR Seat InstallationAttach Restraint Belt F Position Restraint Belt FLower Seat Back Raise Handle Install Infant CAR SeatBritax Engage CAR Seat Fasten Restraint BeltEngage CAR Seat Peg PéregoRaise Seat Back Position Handle Position CAR Seat Tighten Restraint BeltRaise Seat Back Position Handle Remove Accessory BARGraco Britax Peg Pérego To Remove CAR SeatSET Parking Brake Remove CAR Seat GracoEngage Tray Tray InstallationRemove Screws Remove Accessory BAR Rotate TrayRemove Sharp Screw and Belt Remove Restraint Belt MRemove Restraint Belt F Replace Sharp ScrewInfant Car Seat Adapter Warnings Limited Warranty Warranty claims must be made through an authorized dealer