BOB AA000001 Tray Installation, Remove Screws Remove Accessory BAR, Engage Tray, Rotate Tray

Page 9

TRAY INSTALLATION

Children should not be placed directly in the BOB Stroller seat with the ICSA installed, unless tray is installed for safety and protection.

REMOVE SCREWS

REMOVE ACCESSORY BAR

Using a Phillips screwdriver, remove both screws.

TIP: Attach short screws to accessory bar for future use.

CAUTION: Ends of accessory bar are sharp!

ENGAGE TRAY

Hook tray onto main bar.

Using a Phillips screwdriver, remove long screws from tray.

ROTATE TRAY

Rotate tray towards stroller seat until it rests on main bar.

SECURE TRAY

Insert long screw through each hole in tray, main bar and into nut on underside of tray.

Tighten firmly with Phillips screwdriver.

Line up holes.

OMA09D

P9

Image 9

Contents Infant Car Seat Adapter Instructions Accessory BarAttach Main BAR Attach Restraint Belt M Attach Restraint Belt M/F and ArmsAttach Restraint Belt F Prepare Stroller for Infant CAR Seat InstallationBuckle Belt Position ARM Position Restraint Belt FBritax Install Infant CAR SeatLower Seat Back Raise Handle Engage CAR Seat Fasten Restraint BeltRaise Seat Back Position Handle Position CAR Seat Peg PéregoEngage CAR Seat Tighten Restraint BeltRemove Accessory BAR GracoRaise Seat Back Position Handle SET Parking Brake Remove CAR Seat To Remove CAR SeatBritax Peg Pérego GracoRemove Screws Remove Accessory BAR Tray InstallationEngage Tray Rotate TrayRemove Restraint Belt F Remove Restraint Belt MRemove Sharp Screw and Belt Replace Sharp ScrewInfant Car Seat Adapter Warnings Warranty claims must be made through an authorized dealer Limited Warranty