BOB AA000001 manual Peg Pérego, Raise Seat Back Position Handle Position CAR Seat, Engage CAR Seat

Page 6

Peg Pérego®

RAISE SEAT BACK

See the “Reclining Seat” section of your stroller owner’s manual.

POSITION HANDLE	POSITION CAR SEAT
Move car seat handle	Place car seat
into upright carrying	Place car seat
position.	“rear facing”
	onto ICSA
	accessory bar,
	in a straight
	downward
	motion.

ENGAGE CAR SEAT

FASTEN RESTRAINT BELT

Slide grooves on underside of car seat onto ICSA accessory bar.

Fasten restraint belt over top of infant car seat as shown.

TIGHTEN RESTRAINT BELT

Pull on red ring to tighten.

Warning

Be sure restraint belt tension is not constricting child as it may cause serious injury.

DOUBLE CHECK CAR SEAT IS SECURELY ATTACHED

Pull car seat upward without removing restraint belt.

You should not be able to remove car seat without unfastening restraint belt.

Warning

Failure to securely attach car seat may result in serious injury or death.

TO REMOVE Peg Pérego®

Go To

OMA09D

P6

Image 6

Contents Accessory Bar Infant Car Seat Adapter InstructionsAttach Main BAR Attach Restraint Belt M/F and Arms Attach Restraint Belt MBuckle Belt Position ARM Prepare Stroller for Infant CAR Seat InstallationAttach Restraint Belt F Position Restraint Belt FLower Seat Back Raise Handle Install Infant CAR SeatBritax Engage CAR Seat Fasten Restraint BeltEngage CAR Seat Peg PéregoRaise Seat Back Position Handle Position CAR Seat Tighten Restraint BeltRemove Accessory BAR GracoRaise Seat Back Position Handle Britax Peg Pérego To Remove CAR SeatSET Parking Brake Remove CAR Seat GracoEngage Tray Tray InstallationRemove Screws Remove Accessory BAR Rotate TrayRemove Sharp Screw and Belt Remove Restraint Belt MRemove Restraint Belt F Replace Sharp ScrewInfant Car Seat Adapter Warnings Limited Warranty Warranty claims must be made through an authorized dealer