ATTACH RESTRAINT BELT M/F AND ARMS
LOCATE FABRIC SCREWS | REMOVE FABRIC SCREW |
Extend canopy to expose |
|
lower fabric screw. | Remove screw with |
| Phillips screwdriver, |
| exposing fabric |
| grommet and |
| rivet nut. |
Repeat on other side.
ATTACH RESTRAINT BELT M
POSITION ARM
Position arm between canopy and frame.
Align arm hole over fabric grommet and rivet nut.
INSERT SHARP SCREW
Insert sharp screw through end of arm, restraint belt grommet, fabric grommet and into rivet nut.
POSITION RESTRAINT BELT M
Slide restraint belt M grommet between end of arm and fabric grommet.
Red pull ring should face out.
TIGHTEN SHARP SCREW
Hold strap at a 90 degree angle.
90°
Tighten firmly with
Phillips screwdriver.
Note:
If screw does not turn easily, unscrew and start again.
OMA09D | P3 |