BOB AA000001 manual Graco, Raise Seat Back Position Handle, Remove Accessory BAR

Page 7

Graco®

See the “Reclining Seat” section of your stroller owner’s manual.

Move car seat handle into upright carrying position.

Using a Phillips screwdriver, remove both screws.

TIP: Attach short screws to accessory bar for future use.

CAUTION: Ends of accessory bar are sharp!

POSITION CAR SEAT

Place car seat “rear facing” onto ICSA main bar, in a straight downward motion.

Slide grooves on underside of car seat onto ICSA main bar.

Red hook on Graco® should be under main bar.

FASTEN RESTRAINT BELT

Fasten restraint belt over top of infant car seat as shown.

OMA09D

Image 7

Contents Infant Car Seat Adapter Instructions Accessory BarAttach Main BAR Attach Restraint Belt M Attach Restraint Belt M/F and ArmsPosition Restraint Belt F Prepare Stroller for Infant CAR Seat InstallationAttach Restraint Belt F Buckle Belt Position ARMEngage CAR Seat Fasten Restraint Belt Install Infant CAR SeatBritax Lower Seat Back Raise HandleTighten Restraint Belt Peg PéregoRaise Seat Back Position Handle Position CAR Seat Engage CAR SeatGraco Remove Accessory BARRaise Seat Back Position Handle Graco To Remove CAR SeatSET Parking Brake Remove CAR Seat Britax Peg PéregoRotate Tray Tray InstallationRemove Screws Remove Accessory BAR Engage TrayReplace Sharp Screw Remove Restraint Belt MRemove Restraint Belt F Remove Sharp Screw and BeltInfant Car Seat Adapter Warnings Warranty claims must be made through an authorized dealer Limited Warranty