BOB AA000001 manual Install Infant CAR Seat, Britax, Lower Seat Back Raise Handle

INSTALL INFANT CAR SEAT

When installing car seat in the ICSA for the first time, test fit with

the car seat unoccupied to ensure you understand the process. Warning Installing occupied Infant Car Seat on ICSA for first time may result

in accident, serious injury or death.

Britax® Go To Peg Pérego® Go To Graco® Go To

Britax®

LOWER SEAT BACK

Lower seat back 7” to 8”. See “Reclining Seat” section of your stroller owner’s manual.

RAISE HANDLE	POSITION
	CAR SEAT

Place car seat “rear facing” onto ICSA accessory bar, in a straight

downward motion.

Move car seat handle into upright carrying position.

ENGAGE CAR SEAT FASTEN RESTRAINT BELT TIGHTEN RESTRAINT BELT

Slide grooves on underside of car seat onto ICSA accessory bar.

Fasten restraint belt over top of infant car seat as shown.

DOUBLE CHECK CAR SEAT IS SECURELY ATTACHED

Pull car seat upward without	Warning
removing restraint belt.
You should not be able to	Failure to securely attach
remove car seat without	car seat may result in
unfastening restraint belt.	serious injury or death.

Pull on red ring to tighten.

Warning

Be sure restraint belt tension is not constricting child as it may cause serious injury.

TO REMOVE Britax®

Go To

OMA09D P5