Graco ISPC054BA manual Harness Straps fig. a, Harness Tie, Overhead Shield Models

Page 20

OPERATIONS and ADJUSTMENTS

1HarnessStraps(fig.a):

•To tighten: Pull lower belt tab.

•To loosen: Pull and hold upper belt tab while pulling shoulder harness straps.

2HarnessTie:

•To open: Press tabs and pull apart.

•To close: Snap halves together. Make sure harness tie is locked by pulling out on each half.

3Buckle:

MUST be in opening closest to but not under child.

5-PointModels

•To buckle: Insert both tongues into buckle. Pull up on tongues to be sure they are locked.

•To unbuckle: Press red button and pull tongues out of buckle.

OverheadShieldModels

•To buckle: Push tongue into opening. Pull up on tongue to be sure it is locked.

•To unbuckle: Press red button, pull tongue out of opening and lift shield

18over top of child restraint.

4Recline/UprightPositions(fig.b):Rear-facing- MUST use Recline position.

Forward-facing- MUST use Upright position

Upright Position: Rotate stand out and push into child restraint (fig. b).

Recline Position: Pull stand out and rotate into child restraint.

Harness straps MUST move freely. Make sure harness straps are not pinched by recline stand.

55-PointCrotchStrapAdjustment(fig. c):

•From bottom of child restraint, pull crotch strap clip out and remove clip from crotch strap loop.

•From top of child restraint, pull crotch strap out and thread through desired slot. Make sure red button is facing away from child.

•From bottom of child restraint, re-attach clip to crotch strap loop exactly as shown.

6OverheadShieldAdjustment(fig.d):

•To adjust: Press button down and slide shield to desired position closest to child. Release button to lock shield into one of multiple positions.

NOTE: Shield does not need to contact child when in closest position; harness system restrains child.

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Page Table of Contents Registration Information Safety First Check ListImportant Information Page Page Vehicle Seat Protection Basic InformationCertification What is LATCH? Latch System for VehiclesVehicle Lower Anchor Points Vehicle Seat CreaseLatch System Fig. a Child Restraint Lower Anchorage BeltHeight & Weight Limits Outgrowing Child RestraintRear-facing 5 to 30 lbs .2-13.6 kg Forward-facing 20 to 40 lbs to 18 kgREAR-FACINGINSTALLATION with Latch Fig. e Fig. dFORWARD-FACING Installation with Latch FORWARD-FACING Installation with Latch Tether Openings Pull to tightenREAR-FACING Installation with Vehicle Seat Belts Lap/shoulder belt FORWARD-FACING Installation with Vehicle Seat Belts FORWARD-FACING Installation with Vehicle Seat Belts Placing Child in Child Restraint Check harness systemPoint Models Only Overhead Shield Models OnlyPlacing Child in Child Restraint Point Crotch Strap Adjustment fig. c Overhead Shield Adjustment fig. dHarness Straps fig. a Harness TieRecline Clip Upright Upper TabLower Tab Changing Harness Strap Slots Point Models fig. e For Infants or Small ToddlersFor Toddlers Overhead Shield Models fig. fTop Loop Bottom Loop Splitter PlateLatch Belt Routing Latch belt. figFig. k Removing Latch from Vehicle Anchor Points Fig. mLatch storage Fig. q or rVehicle Seat Belts Vehicle Seat Belts Belts Forward of Seat CreaseFlip Lap Belts Manually AdjustableLap Belts With Retractor Passive Restraint Lap Belt with Motorized Shoulder Belt Passive Restraint Lap or Shoulder Belt Mounted on DoorPull Combination Lap/Shoulder Belt with Sliding Latch PlateCombination Lap/Shoulder Belt with Locking Latch Plate Locking Clip Additional Information Tether StorageFor storage of tether hook Tether Hook Back of Child RestraintRemoving Cup Holder Cup HolderAvailable on some models Additional Information Removing Overhead Shield Pad Care & CleaningRemoving Seat Pad all models Aircraft Use Seat Pad and Overhead Shield PadHarness Straps and Latch belt Shell and Overhead Shield Cup HolderPage Replacement Parts How to OrderShip to Model No ManufacturedCall US First Manual de instrucciones Tabla DE Contenido Antes de EmpezarUtilización Información especialLista de control de seguridad Información ImportanteInformación de registro Advertencia Prevenga lesiones graves o la muerte Orientación trasera debe nivelarse Advertencia Información BásicaAnclaje ¿QUÉ ES EL LATCH?Sistema Latch para vehículos Sistema Latch El sistema LatchAnclaje Superior del Punto de anclaje Superior del Vehículo Asiento de seguridadLímites DE Altura Y Peso Orientados hacia delante de 20 a 40 libras de 9 a 18 kgInstalación Orientada Hacia Atrás CON Latch Anclaje Aperturas Toallas Instalación Orientada Hacia Delante CON Latch Anclaje Aperturas Jale para Apretar Almacene el cinturón Latch vea la página 25, fig. q Guardado Toallas Instalación con cinturón de Seguridad para la cintura / hombroAjústelo si es necesario Fig. d Colocar AL Niño EN EL Asiento DE Seguridad Compruebe el sistema del arnésModelos Operaciones Y Ajustes Reclinada ClipVertical Modelos con barra protectora fig. f Modelos de 5 puntos fig. e Para bebés o niños pequeñosPara niños más grandes Fig. e Bucle Placa de unión Fig. f SoporteColocación del cinturón Latch Usar el sistema Latch orientado hacia atrás. o Retirar el Latch de los puntos de anclaje del vehículo Barra de almacenaje Almacenaje LatchAbroche el sistema Latch en la barra de Cinturones DE Seguridad DEL Vehículo Cinturones ubicados delante del pliegue del asiento Pliegue del AsientoDéle la vuelta Cinturones de regazo ajustables manualmenteCinturones de regazo con retractor No SE Debe usar con ningún asiento Jale Fig. a Déle la vueltaPulgada 1 cm Gancho del anclaje Parte trasera del asiento de seguridad Información AdicionalAlmacenaje del anclaje Portabebidas Disponible en algunos modelosPara quitar el portabebidas PestañaEl cojín del cuerpo Retirar la almohadilla de la barra protectora Cuidado y limpiezaLos Modelos Asiento de seguridad para autos de segunda mano Las almohadillas del asiento y de la barra protectoraArmazón y apoyavasos de la barra protectora HebillaNotas Lista DE Piezas Cómo efectuar pedidosEnvíe a De modelo Fabricado enLlámenos Primero

ISPC054BA specifications

The Graco ISPC054BA is a cutting-edge infant car seat designed to provide safety, comfort, and ease of use for both parents and their little ones. With a range of features and technologies, this car seat aims to enhance the traveling experience for families while ensuring the utmost protection for infants.

One of the standout features of the ISPC054BA is its TrueShield Technology, which incorporates advanced side impact protection. This system is designed to absorb and distribute crash forces, thereby reducing the risk of injury in the event of an accident. The car seat also meets or exceeds all safety standards set by the National Highway Traffic Safety Administration (NHTSA), offering parents peace of mind when traveling.

Comfort is another essential characteristic of the ISPC054BA. It boasts a plush infant insert that provides additional support for newborns, ensuring a snug and secure fit. The head support is adjustable, allowing it to grow with the child, while the seat includes a five-point harness that can be easily adjusted to accommodate infants as they grow. The installation process is straightforward, featuring Graco’s InRight LATCH system, which allows for quick and secure installation in vehicles.

In terms of convenience, the ISPC054BA is designed with parents in mind. The car seat features a lightweight design that makes it easy to carry and transfer between vehicles. An ergonomic handle provides comfort during transport, while the built-in canopy offers protection from the sun and rain during outdoor activities.

Another notable characteristic is the versatility of the ISPC054BA. It seamlessly transitions from car to stroller, making it an excellent addition to a travel system. The car seat is compatible with various Graco strollers, allowing parents to create a convenient travel solution without disturbing their sleeping baby.

Maintenance is also a breeze with this model. The car seat cover is removable and machine washable, ensuring that it remains clean and hygienic for everyday use. Parents will appreciate this feature, especially during messy outings.

In conclusion, the Graco ISPC054BA is a reliable infant car seat that combines safety, comfort, and convenience. With its innovative features like TrueShield Technology, easy installation, and compatibility with Graco strollers, it stands out as a top choice for modern families seeking a dependable and user-friendly car seat solution.
Top Page Image Contents