Graco deluxe series manual Adjusting the handle Attaching Car seat to the base, On certain models

1

2

Adjusting the handle		Attaching the
		car seat to the base
Squeeze latches on both sides
		(on certain models)
at bottom of handle to release it.
		NOTE: A base for your seat (which
Rotate handle into one of three
locking positions—carrying (up),		stays buckled in the car, so you can
reclining (middle) or sitting (fully		avoid fastening the vehicle belt each
down). Be sure it locks into desired		time you go out) is sold separately
position and latches pop out.		through certain retailers.
Always place handle in the up	3	To attach seat to base, position front
position when using the car seat in		of seat in base then push down on
a vehicle.		the back until it locks into place.
Always place handle in the down		(See Illustration).
position when removing your baby		Pull up on car seat to be sure it is
from the seat.		securely latched into base.
	4	To remove, squeeze release handle

at back of the car seat to release the attachment latch. Lift car seat from base as shown.

23