Choosing the seat location

!For a smaller baby, use the lower shoulder slots and the upper strap loops.

The ends of the straps must hang in front of the junction plate.

Lift up the strap ends to check that the loops are completely within the junction plate slots and pull on the straps to be sure they are secure.

!For a larger baby, use the upper shoulder slots and the end strap loops.

Check that the straps are completely within the junction plate slots and pull on the straps to be sure they are secure.

WARNING: Use extreme care in threading the straps according to the diagram. If the straps are not secure, they will not protect your baby.

See fitting chart on page 88-89 for specific vehicle seating position.

15 DO place car seat in a forward-facing vehicle seat. The seat can be placed on the rear or front seat of the car (except cars fitted with a passenger air bag).

16	DO NOT place car seat in a vehicle
	seat that uses an air bag.
17	DO NOT place car seat in a
	rear-facing vehicle seat.
18	DO NOT place car seat in a
	side-facing vehicle seat.

The car seat alone must be fastened in the car with a three point belt with or without a retractor, which has been approved to ECE regulation No. 16 or equivalent standard. Base could be used with both 2 or 3 point belts.

Choosing the seat location

side-facing vehicle seat.