This section of the Rear Panel as we mentioned earlier, while explaining the CHANNEL ASSIGN section, is provided to make possible the triggering of the
sources. The six 1/4 inch jacks represent all four Modes of operation and the two channels' Graphic Equalizers. These functions may be controlled by connecting most any "tip to ground" type switcher to the appropriate jacks and grounding them. This method of Mode selection is provided so that the
EXTERNAL SELECT
9A S.B. | TUBE | FET |
FUSE |
|
|
250 VOLTS | EQ | EQ |
117 VAC 60Hz 1200VA | TUBE | MIX | |
HI GAIN | MODE | ||
|
NOTE |
| If you wish to use the External Select Jacks to call up a Mode or E.Q., you must have the Rotary Mode Select Switch |
(located | on the right side of the Rear Panel) set to the EXT position. These External Select Jacks can always be used to select a |
Mode, regardless of the state of any other switching logic.
FUSE This is the A.C. Mains Fuse for the
HIGH OUTPUT LEVEL SETTINGS.
FUSE RATING ( USA ) 10 A S.B. / 250 VOLTS ONLY | = 117 |
FUSE RATING ( IEXPORT ) 6 1/4 A S.B. / 250 VOLTS ONLY = All Others
100 / 220 / 230 / 240
The "Euro Style" A.C. cord connector that is supplied with the
It also makes
EXTERNAL SELECT
9A S.B. | TUBE | FET |
|
| |
FUSE | EQ |
|
| EQ | |
250 VOLTS |
|
|
117 VAC 60Hz 1200VA | TUBE | MIX |
HI GAIN | MODE | |
9A S.B. | EXTERNAL SELECT | |
TUBE | FET | |
FUSE |
|
|
250 VOLTS | EQ | EQ |
|
|
117 VAC 60Hz 1200VA | TUBE | MIX |
HI GAIN | MODE |
SPEAKER OUT | SPEAKER |
| OUT |
CAUTION: NEVER BLOCK AIR VENTS SUGGESTED LOAD 4 OHMS
600 WATTS RMS MINIMUM LOAD 2 OHMS
CAUTION: NEVER BLOCK AIR VENTS
| SPEAKER |
SPEAKER OUT | OUT |
CAUTION: NEVER BLOCK AIR VENTS
EPILOGUE We hope this manual has answered most of your operating questions and that you now feel confident to start experimenting on your own. The
the
PAGE 12