Yamaha YSP-3050 owner manual Show Result, 34 En

AUTO SETUP (IntelliBeam)

8Check that the following screen is displayed on your TV.

The results of the AUTO SETUP procedure are displayed on your TV.

Example 1

SHOW RESULT

MEASUREMENT COMPLETE ← Flashes

BEAM MODE :5 BEAM

SUBWOOFER :NOT APPLICABLE

[ENTER]:Save set-up. [RETURN]:Do not save set-up.

Example 2

SHOW RESULT

MEASUREMENT COMPLETE ← Flashes

ENVIRONMENT CHECK[FAILED]

BEAM MODE :5 BEAM

SUBWOOFER :YES

[ENTER]:Save set-up. [RETURN]:Do not save set-up.

y

•If “ENVIRONMENT CHECK [FAILED]” is displayed, we recommend running the AUTO SETUP procedure again. For details, see step 9.

•If “SUBWOOFER : NOT APPLICABLE” is displayed even though a subwoofer is connected to this unit, increase the volume level of the subwoofer and run the AUTO SETUP procedure again.

•Depending on the environment of your listening room, the beam angle of front left and right, and surround left and right may be set to the same value even if

“5 BEAM” is displayed as a result.

9Press ENTER to confirm the results or press RETURN to cancel the results.

The following screen is displayed for two seconds and then disappears from your TV.

AUTO SETUP COMPLETE

Please remove the MIC from

ENTERthe YSP and the listening position.

If “ENVIRONMENT CHECK [FAILED]” is displayed in step 8, the following screen is displayed after pressing ENTER. In this case, see ERROR E-1 in “Error messages for AUTO SETUP” on page 35. Press ENTER to exit AUTO SETUP and then run the procedure again from step 3.

AUTO SETUP COMPLETE

Your YSP unit may not be set up correctly.

We recommend you try again.

Please press [ENTER] key to exit.

10Disconnect the IntelliBeam microphone from the INTELLIBEAM MIC jack on the front panel.

y

If you want to save and load settings, see “Using the system memory” on page 36.

34 En