Yamaha YSP-3050 102 En, Remote control, Hdmi, FM tuner, page, The remote control does not

Troubleshooting

■Remote control

	Problem	Cause	Remedy	See
				page
The remote control does not		Wrong distance or angle.	The remote control functions within a	24
work and/or function			maximum range of 6 m (20 ft) and no more
properly.			than 45 degrees off-axis from the front panel.
		Direct sunlight or lighting (from an inverter	Reposition this unit.	—
		type of fluorescent lamp, etc.) is striking the
		remote control sensor of this unit.
		The batteries are weak.	Replace all batteries.	24
Cannot operate external		The external component you want to operate	Press INPUT on the front panel or the input	39
components with the remote		is not selected as the input source.	selector buttons on the remote control to
control of this unit.			select the external component you want to
			operate.
		The remote control code was not correctly	Set the remote control code correctly or try	94
		set.	another code for the same manufacturer
			using the “List of remote control codes” at
			the end of this manual.
		Even if the remote control code is correctly	Use the remote control supplied with the	—
		set, there are some models that do not	external component.
		respond to the remote control.
The cursor buttons do not		The operation mode selector was	Set the operation mode selector to YSP.	—
work during SET MENU		unwantedly set to TV/AV.
operation.
Cannot use the My Beam		Wrong distance or angle.	The remote control functions within a	24
auto-adjust function.			maximum range of 6 m (20 ft) and no more
			than 45 degrees off-axis from the front panel.
■	HDMI
	Error message	Cause	Remedy	See
				page
Device Error		The number of the connected HDMI	Reduce the number of the connected HDMI	—
		components exceeds the limit.	components.
HDCP Error		HDCP authentication failed.	Check that the connected HDMI	—
			components support the HDCP copy
			protection standards.
Out of Resolution		The resolution of the HDMI output signals	Adjust UP-SCALING.	84
		exceeds the limit allowed by your TV.
■	FM tuner
	Problem	Cause	Remedy	See
				page
FM stereo reception is noisy.		The characteristics of FM stereo broadcasts	Check the antenna connections.	23
		may cause this problem when the
			Try using a high-quality directional FM	—
		transmitter is too far away or the antenna
		input is poor.	antenna.
			Use the manual tuning method.	43
There is distortion, and clear		There is multi-path interference.	Adjust the antenna position to eliminate	—
reception cannot be obtained			multi-path interference.
even with a good FM
antenna.
The desired station cannot		The signal is too weak.	Use a high-quality directional FM antenna.	—
be tuned into with the
			Use the manual tuning method.	43
automatic tuning method.
Previously preset stations		This unit has been disconnected for a long	Preset the stations again.	44
can no longer be tuned into.		period.

102 En