TIMING CHART OF EXTERNAL TRIGGER SHUTTER - MODE 2 
(RESET MODE)
For setting the shutter speed using TRG width
|
|
| Mode transition state | |
|
|
| External input | External trigger |
|
| *3 Normal operation | inhibition area | |
| External trigger shutter operation | (50 ms) | shutter operation | |
| 1 |
|
| 2 |
*1 Trigger |
| *3 Trigger |
|
|
|
|
|
| |
| *2 Exposure time Te |
|
| *2 Exposure |
|
|
|
| time Te |
Video out | 1 |
|
| 2 |
| *4 1H to 2H |
|
| *4 1H to 2H |
WEN |
|
|
| |
|
|
|
| |
| 250H | 250H |
| 250H |
|
| |||
|
| |||
| 293H | 293H |
| 293H |
|
| |||
|
| |||
*1:
*2:
*3:
*4: *5:
This is a signal input from the outside. The trigger interval should be trigger pulse width + 1 field + 2H period or more. The trigger interval shorter than described above cannot be ensured. If a trigger pulse is not input under the prescribed conditions, the normal operation is ensured several V after a change in input operation under the prescribed conditions.
Exposure time Te Te = Trigger width + 97 μs
Te = Trigger width + 120 μs
The normal operation state is engaged when the high period exceeds 1/3 sec. After that, the external trigger shutter operation is engaged when the trigger pulse goes “low”. In this case, the area between the falling edge of a trigger pulse and the subsequent 50 ms period is an external input inhibition area. During the trigger inhibit period, an input trigger may be missed.
A VD signal is generated 1H to 2H after a trigger pulse falls, and an image is output in synchronization with the VD signal.
When the external trigger shutter mode changes into the normal operation mode, a WEN signal is output.
28