Pelco IS90 manual Deep Electrical Box Installation

Page 17

NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.

6.Attach the back box to the adapter plate with two 8-32 x 0.75-inch Phillips pan head self-tapping screws (supplied).

4S DEEP ELECTRICAL BOX

CEILING/

WALL

8-32 X 1.00-INCH PHILLIPS PAN HEAD SCREWS (SUPPLIED)

8-32 X 0.75-INCH PHILLIPS PAN HEAD SCREWS (SUPPLIED)

ADAPTER PLATE (SUPPLIED)

BACK

BOX

Figure 10. 4S Deep Electrical Box Installation

C3425M-E (1/09)

17

Image 17

Contents IS90 Series Camclosure Page Contents List of Illustrations Radio and Television Interference Regulatory NoticesModels DescriptionIS90B-DNV9 IS90B-DNV9X Parts ListShown Actual Size Removing the Bubble Remove the BubbleUnshielded Twisted Pair UTP Video InstallationSurface Installation CEILING/WALL Ceiling/ Wall Installation Removing the Surface Mount Ring from the Back Box IN-CEILING Installation Suspended CeilingCeiling Tile Installation with Surface Mount Ring IN-CEILING Installation Fixed CEILING/WALL In-Ceiling Installation to a Fixed Ceiling/Wall Surface Installation 4S Standard Electrical BOXStandard Electrical Box Installation IN-CEILING Installation 4S Deep Electrical BOXDeep Electrical Box Installation Varifocal Lens Zoom and Focus Adjustments Camera AdjustmentsAdjusting the Focus Switch Settings DN/CH/C Series AdjustmentsAuto Iris Level Adjustment Blemish Detection DAY/NIGHT Operation SW1-2 Line Sync DW/CW Series Wide Dynamic Range AdjustmentsSW1-4 Auto White Balance/Manual White Balance SW1-8 Day/Night Operation DW models only Auto Iris Level Adjustment Positioning the Camera Camera PositioningInstalling the Bubble Install Liner and BubbleService Connector Service ConnectorAttaching the 2.5 mm Monaural Headphone Plug General SpecificationsCAMERA/LENS Revision History Product Warranty and Return Information