4.Remove an adjacent ceiling tile to access the unit.
5.Connect the video cable and wires:
•BNC: Connect the BNC connector from the unit to a mating BNC connector.
•UTP: Connect the blue wire to Video +; connect the gray wire to Video
6.Connect the power wires (refer to Table B).
Table B. Power Input:
Voltage | Red Wire | Black Wire |
|
|
|
12 VDC | + | Ground |
|
|
|
24 VAC | ~ | ~ |
|
|
|
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.
NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
7. Reinstall the adjacent ceiling tile.
IN-CEILING INSTALLATION: FIXED CEILING/WALL
1.Remove the surface mount ring from the back box (refer to Figure 5 on page 12):
a.Place your fingers on the circular marks 
located on the sides of the surface mount ring.
b.Pinch the sides.
c.Lift and remove the surface mount ring from the back box. Do not discard the surface mount ring, it is required to complete the installation.
2.Cut a hole 4 inches (10 cm) in diameter in the ceiling/wall (refer to Figure 8 on page 15).
3.Pull the video and power wires through the opening.
4.Connect the video cable and wires:
• BNC: Connect the BNC connector from the unit to a mating BNC connector.
• UTP: Connect the blue wire to Video +; connect the gray wire to Video
5.Connect the power wires (refer to Table C).
Table C. Power Input:
Voltage | Red Wire | Black Wire |
|
|
|
12 VDC | + | Ground |
|
|
|
24 VAC | ~ | ~ |
|
|
|
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.
NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
14 |