Samson GT100C manual Setting Up and Using Your Hartke GT100 Guitar Amplifier, Select Channel

ENGLISH

Setting Up and Using Your Hartke GT100 Guitar Amplifier

8.Adjust the CHANNEL 1 BASS and Treble equalizer controls to taste. (When you get a great setting that complement your

instrument and playing style, it’s a good idea to write it down for future use.) Also, see the section GT100 Sample Settings on page 44 in this manual.

9. Next, experiment with the CRUNCH control. You'll know that the CRUNCH control is active when its red LED is illu- minated. You can select it on or off using button 1 on the included footswitch. If the footswitch is not connected, the CRUNCH is always on and its red LED will stay lit. You can turn the CRUNCH control all the way down (fully counterclock- wise) to bypass the control when the footswitch is not con- nected as well.

#( 	10. Now, press the CHANNEL SWITCH (or the footswitch) to
	select CHANNEL 2.

11. Set the CHANNEL 2 GAIN to “10” position (fully clockwise) and then, while playing, slowly turn the GT Series CHANNEL 2 VOLUME control up until the desired level is achieved.

NOTE: With the GAIN control on “10” you will get the most overdrive from CHANNEL 2. You can turn down the GAIN control for less distortion.

12. Adjust the CHANNEL 2 BASS, MID and TREBLE equalizer controls to taste. (When you get a great setting that comple- ment your instrument and playing style, it’s a good idea to write it down for future use.)

13. Test the headphone output by turning the active chan- nel's Volume control to its minimum (fully counterclockwise) position and then connect a standard stereo headphone to the front panel Phones jack. While playing your guitar, slowly turn the Volume control up—you should hear sound from the headphones and none from the connected speaker.