Honeywell HCC-745NTW/PTW operation manual Installation

3.Installation

3.1The packing box should include, in addition to this User Guide: -. One HCC-745NTW or HCC-745PTW camera

-. One 6-pin connection cable ( G-113510-200 ) -. One Auto Iris lens plug

3.2Mounting a Lens

3.2.1 C/CS Mount Lens

①Remove the protective cap in front of the camera.

② Adjust the mount ring whether it is for C or CS.

③ Loosen Set Screw.

④ Turn the mount ring counterclockwise in case of C-Mount Lens. Turn the mount ring clockwise in case of CS-Mount Lens

3.2.2 Auto Iris Lens

①Remove the cover of the auto iris lens plug and connect with the lens cable.

② Connect the auto iris lens plug to the 4-pin lens terminal on the side of the camera.

③ Set the EE MODE to ALC MODE on the OSD menu ( see 5.6 AE MODE) -. Auto iris lens with no amplifier : Set the DC LENS on the OSD menu -. Auto iris lens with amplifier : Set the VSD LENS on OSD menu

☞Adjust by using “LENS ADJ.” on OSD menu to avoid hunting.

		VSD LENS PIN CONFIGURATION				DC IRIS LENS PIN CONFIGURATION
		4			①③	3	4		①③
					②④	1			②④
	1						2
		2
1.	POWER(12V)			2.	NO CONNECTION	1. CONTROL-		2.	CONTROL+
3.	VIDEO SIGNAL			4.	GND
						3. DRIVE+		4.	DRIVE-
			Set the select switch to VSD				Set the select switch to DC

- 8 -