JAI CV-M77 operation manual pin DSUB-connector RGB/SYNC

	CV-M77
	See section 8 “Switch Settings” and section 9 “Jumper Settings ” for more information.
*)	When using the WEN signal from the 6 pin connector do not use the same signal from the
	9 pin connector.
*)	Signals shown in bold italics are factory settings.

5.39-pin DSUB-connector (RGB/SYNC.)

Pin No.	5.3.1.1 Signal	5.3.1.2 Remarks
1*	NC	VD input: JP303 “open” and JP304 “short”
2	GND
3	R output
4*	G output	Sync. on G: SW302-3 “ON”
5	B output
6*	HD input	HDinput: SW303-1 “ON”. HDout: SW303-1 “OFF”
7*	Sync output	WEN output: SW302-4 “ON”
8	GND
9*	NC	PCLK output: JP305 “open” and JP306 “short”

Notes:
*)	Signals on pin no. 1,4, 6,7 and 9 can be changed by jumper setting.
	See section 8 “Switch Settings” and section 9 “Jumper Settings ” for more information.
*)	In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.
*)	When using the HD/VD, PCLK and WEN signals (input or output) from the 9-pin D-SUB
	connector do not use the same signals (input or output) from the 12 pin or 6 pin
	connectors.
*)	Signals shown in bold italics are factory settings.

- 8 -