JAI CV-M77 Pin Assignment, pin Multi-connector DC-IN/SYNC, pin Multi-connector RS 232C/TRIGGER

CV-M77

5 Pin Assignment

5.112-pin Multi-connector (DC-IN/SYNC.)

Type: HR10A-10R-12PB-01 (Hirose male) Seen from rear.

1 9

2 10 8

3 11 12 7

46

5

Pin No.		5.1.1.1	Signal	5.1.1.2 Remarks
1		5.1.1.3	GND
2		+12V DC input
3		GND
4		NC
5		GND
6*		Ext.HD input		SW-S301.1 “ON” for 75Ω termination, SW-S303.1 “OFF” for HD output
7*		Ext.VD input		SW-S301.2 “ON” for 75Ω termination, SW-S303.2 “OFF” for VD output
8		GND
9*		NC		PCLK out: JP305 “short”, JP306 “open”
10*		WEN		NC: JP309 and JP310 “open”. GND: JP308 “open” JP309 and JP310 “short”
11*		Ext. trigger		NC: JP401 and JP301* “open”. +12V DC JP401 “short” and JP301* “open”
12		GND
Notes:
*)	Signals on pin no. 6, 7,9,10 and 11 can be changed by jumper setting.
	See section 8 “Switch Settings” and section 9 “Jumper Settings ” for more information.
*)	In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.
*)	When using the HD/VD, PCLK and WEN signals (input or output) from the 12-pin
	connector do not use the same signals (input or output) from the 9 pin D-SUB connector.
*)	JP301 is “short” by a capacitor (factory setting – see section 9 “Jumper Settings”.
*)	Signals shown in bold italics are factory settings.

5.26-pin Multi-connector (RS 232C/TRIGGER)

Type: HR10A-7R-6PB (Hirose male)

Seen from rear.

Pin No.		5.2.1.1 Signal	5.2.1.2 Remarks
1		TXD (RS-232C)
2		RXD (RS-232C)
3		GND
4*		NC	GND: JP402 “short”
5		Ext.TRIG input
6*		EEN output	WEN out: JP312 “open” and JP311 “short”
Notes:
*)	Signals on pin no. 4 and 6 can be changed by jumper setting.
			- 7 -