JAI CV-M77 operation manual Input and Output Circuits, Video input, HD and VD input

Page 9

CV-M77

5.4Input and Output Circuits

In the following schematic diagrams the input and output circuits for video and timing signals are shown. For alternative connections refer to “Internal Switch and Jumper Settings”. Jumper settings are shown as for factory default.

5.4.1Video input

The video output signal is a 75RGB video signal. The signal level is 0.7Vpp. Composite sync. is selectable on the green video signal via software or the internal switch 302-3. The sync. signal level is 0.3Vpp.

+5V

33KB

5.4.2 Trigger input

The trigger input is AC coupled with a flip-flop. The input signal level is 4V ± 2V.

The trigger input impedance is 1.2 kor 75selectable via the internal switch S301-3.

Trigger input

33KB

SC104V

1K8B

SC102V

100KB

75C

S301-3

SC102V

GND

5.4.3HD and VD input

The HD and VD input circuit can be 75terminated via the internal switch S301-1 and S301-2.

The input signal level is 4V ± 2V.

+5V

33KB

HD, VD

SC104V

1K8B

input

SC102V

5.4.4HD, VD, PCLK, WEN and EEN output The output circuits for these signals are 75complementary emitter followers. The single circuit delivers a TTL signal. The output level 4 V from 75(no termination).

TTL

75C

S301-1(HD),2(VD)

+5V

10KB

220B

120C

150C

GND

Int VD Int HD PCKL WEN EEN

10KB

- 9 -

Image 9
Contents CV-M77 CV-M77 Switch Settings Configuring the camera using the serial interfaceJumper settings CV-M77 Camera Control Tool SpecificationsPatterned Noise 12.3 General Standard Composition Main FeaturesCamera Housing and Dimensions 6-pin Multi-connector RS 232C/TRIGGER 12-pin Multi-connector DC-IN/SYNCPin No 1.1 Signal Remarks Pin No Signal Remarks9-pin DSUB-connector RGB/SYNC Input and Output Circuits Video inputHD and VD input External Trigger Mode Input/Output of HD/VD SignalFunctions and Operation Continuous operationExtvd Exthd Pulse Width Control Trigger ModeLong Time Exposure Mode Frame-delay Readout ModeCV-M77 Timing diagram for Edge Pre-select mode Timing diagram for Pulse Width Control modeTiming diagram for Frame-delay Readout mode EEN WEN Timing diagram for Long Time Exposure modeMode Setting using Ascii commands via the RS-232C port Configuring the camera using the serial interfaceCommunication setting Command ProtocolReceiving Data Camera-PC 1023RS232C Cable Connections Response to firmware version request command ExampleMode Settings by Switch Switch SettingsSignals by Switch Settings 1 SW301 switch S3012 SW302 switch S302 S302-1 S302-2 Color temperature3 SW303 switch S303 Jumper locations Jumper settingsPin Jumper tableCV-M77 Camera Control Tool Fig. Windows from the Camera Control Tools software Specifications Spectral sensitivity Typical CCD Characteristics PrecautionsAppendix ReferencesUsers Record Users Mode Settings Users ModificationsIndex Camera type CV-M77 Revision Revision a Serial No ……………