JAI CV-M77 Functions and Operation, Configuring the camera using the serial interface, Appendix

CV-M77

1	General		5
2	Standard Composition		5
3	Main Features		5
4	Camera Housing and Dimensions		6
5	Pin Assignment		7
5.1	12-pinMulti-connector(DC-IN/SYNC.)		7
5.2	6-pinMulti-connector (RS 232C/TRIGGER)		7
5.3	9-pinDSUB-connector (RGB/SYNC.)		8
5.4	Input and Output Circuits		9
5.4.1		Video input	9
5.4.2		Trigger input	9
5.4.3 HD and VD input			9
5.4.4 HD, VD, PCLK, WEN and EEN output			9
6	Functions and Operation		10
6.1	Input/Output of HD/VD Signal		10
6.1.1 Input of External HD/VD signals			10
6.1.2 Output of Internal HD/VD signals			10
6.2	Continuous operation		10
6.3	External Trigger Mode		10
6.3.1 Edge Pre-select Trigger Mode			10
6.3.2 Pulse Width Control Trigger Mode			11
6.3.3		Frame-delay Readout Mode	12
6.3.4 Long Time Exposure Mode			12
6.4	Timing diagram for Horizontal and Vertical Sync. Video Output		13
6.5	Timing diagram for Edge Pre-select mode		14
6.6	Timing diagram for Pulse Width Control mode		14
6.7	Timing diagram for Frame-delay Readout mode		14
6.8	Timing diagram for Long Time Exposure mode		15
7	Configuring the camera using the serial interface		16
7.1	Mode Setting using ASCII commands via the RS-232C port		16
7.2	Communication setting		16
7.3	Command Protocol		16
7.3.1		Receiving Data (Camera->PC)	17
7.4	RS232C Cable Connections		18
8	Switch Settings		19
8.1	Mode Settings by Switch		19
8.2	Signals by Switch Settings		19
8.2.1		SW301 switch	19
8.2.2		SW302 switch	20
8.2.3		SW303 switch	20
9	Jumper settings		21
9.1	Jumper locations		21
9.2	Jumper table		22
10	CV-M77 Camera Control Tool		23
11	Specifications		25
11.1		Spectral sensitivity	26
12	Appendix		27
12.1		Precautions	27
12.2		Typical CCD Characteristics	27
12.2.1		Smear	27
12.2.2		Aliasing	27
12.2.3		Blemishes	27
		- 3 -