•Mouse : If you plan to use a mouse to control you multiplexer, set this to On.
•Key lock : When On, pressing any key or clicking the mouse will open a screen asking for a password.
•Factory Reset : Returns all settings to the factory default. A confirmation screen will ask you if you really want to reset everything.
•Cam No. Offset : When set to On, the multiplexer will adjust the camera numbers based on the Unit Address. Unit 001 will have Cameras 01 to 9, Unit 002 will have Cameras 10 to 18, etc. When set to Off, the cameras will be numbered 01 to 9.
•Mouse setup : If the mouse cannot be worked properly, the user can change the values as follows.
The ranges which can be changed are Min=minimum,
•Master/Slave : When installed as part of a network, this will determine if the unit is a master or slave unit.
•Network Type : The multiplexer can be set to
•Baud Rate : When connected to a network, the baud rate can be set to 1200, 2400, 4800, 9600 or 19200.
•Unit Address : Networked multiplexers can be assigned addresses from 001 to 255.
•Protocol : A is multiplexer protocol.
B1 is dome camera control protocol.
•Exit : Saves your changes and returns to the Main Menu.
ENGLISH
49