Appendix A
Troubleshooting
Problem | Try This |
No Video (black screen) | Check power connections |
No Video (one camera) | Check camera power and coaxial cable |
No Video (jumbled colors) | Make certain multiplexer is set correctly for |
| your system (EIA or CCIR) |
Fuzzy Image (one camera) | Check camera focus |
Bad Video (one camera) | Check the loop through connector. |
| If a cable is attached, make certain it is |
| connected to another video device on the |
| other end. |
Wrong Language | Change the language in the Setup Menu |
Buttons Locked | Unlock buttons in Setup Menu. |
Recorded Video Rolls | Check VCR configuration in Setup Menu. |
| Use the trigger pulse from the multiplexer |
| for optimum synchronization with a time- |
| lapse VCR. |
Tape Plays Only 3x3 | Make certain video cable to the VCR input |
| is connected to the VCR OUT of the |
| multiplexer. |
Too Many Motion Alarms | Adjust sensitivity of motion detection grid. |
| Adjust size of grid required to activate |
| motion alarm. Make certain only the area |
| you want to detect motion is activated. |
Motion Not Detected | Adjust sensitivity of motion detection grid. |
| Adjust size of grid required to activate |
| motion alarm. |
| Make certain the area you want to detect |
| motion is activated. |
|
|
ENGLISH
71