EverFocus EZ610 manual Control Key General Operation Guide, Steps

	Chapter
3 OSD MENU SETUP	3

This chapter introduces how to change RS485 ID and Baud Rate and to configure the camera OSD menu.

STEPS

If you want to connect camera with keyboard or other RS-485 - controller, please refer to Section

3.2RS485 ID & Baud Rate setting. Otherwise, please go to STEP 2. Configure the camera, as described below:

3.1 Control Key General Operation Guide

Switch between Lens and Menu operation

Press and hold ( ~ 5 s) the joystick button for changing the operation mode of the joystick. Red LED: Menu mode, Green LED lens control mode.

Bring Up the General OSD Menu

Simply press the mini-joystick to bring up the general OSD menu.

Note: Make sure, that the joystick is in "MENU" mode (red LED under Joystick).

Navigate among the OSD Menu Items

Turn the mini-joystick up (c) or down (d) to move the cursor up or down.

Change Modes or Setting Parameters

Turn the mini-joystick left (e) or right (f) to adjust the mode or value of settings.

Switch to Sub-menu Screens

When an item with a sub-menu is selected, press inward on the mini-joystick to switch to the sub-menu for further settings. This may also be referred to in the instructions below as “pressing the setup button”. Please refer to the diagram below.

SETUP		EVERFOCUS
1. LENS		DC <┘	DC LENS
2. EXPOSURE		<┘
3. WHITE BAL.		AWB	fBRIGHTNESS +++++++++ 45
4. DAY NIGHT		EXT
5.	3DNR	ON<┘	RETURN RET <┘
6.	SPECIAL	<┘
7. ADJUST		<┘	Sub-Menu
8. RESET		<┘
9.	EXIT	Main Menu

16