3.3.2 LENS
When the SETUP menu is displayed on the screen, please direct the arrow to point to “LENS” by using the UP and DOWN buttons.
The iris opening can be adjusted in DC mode in LENS LEVEL. The level can be adjusted from 0 to 50.
Please select RETURN and press the SETUP button if you would like to return to the previous menu.
3.3.3 EXPOSURE
3.3.3.1 SHUTTER
1.When the SETUP menu is displayed on the screen, please direct the arrow to point to “EXPOSURE”
2.Select the shutter mode by pressing the LEFT or RIGHT button.
Select from x256, x128, x64, x32, x16, x8, x4, x2, 1/60 (1/50 at PAL), FLK, 1/250, 1/500, 1/1000, 1/2000, 1/5000, 1/10000, 1/100000 for NTSC model or x256, x128, x64, x32, x16, x8, x4, x2, 1/50, FLK, 1/250, 1/500, 1/1000, 1/2000, 1/5000, 1/10000, 1/00000 for PAL model.
FLK: Please select “FLK” mode when flickering occurs on the screen, because of an
irregular balance between illumination and frequency. NTSC model: 1/100, PAL model: 1/120.
3.Select RETURN and press the SETUP button when you finish all the settings.
NOTE: Make sure for default setting 1/60 (NTSC) / 1/50 (PAL) , if
3.3.3.2 AGC (Auto Gain Control – basic low light signal amplification)
Please direct the arrow to point to “AGC” by using the UP and DOWN buttons.
Select the level you would like to choose by pressing the LEFT or RIGHT button. The more the level of gain increases, the brighter the screen, but the level of noise increases as well. Please select from HIGH, MIDDLE, LOW and OFF.
Note: AGC must be on for
3.3.3.3
Please direct the arrow to point to
AUTO: Low light level auto mode. Press SET for adjusting the maximum number of interpolated images. (Default is Auto, 8X)
OFF: The function is disabled.
Press select RETURN and the SETUP button when you finish all the settings.
20