Elation Professional 05 FOCUS SPOT 250R, 28, Rev 10 instruction

Focus Spot 250R™

2.Tap the UP button until “SPEC” is displayed, press ENTER.

3.Tap the UP button until “DLAY” is displayed, press ENTER.

4.The display will show “D-XX.”

5.Press the UP and DOWN buttons to adjust the delay time.

6.When completed press ENTER to confirm.

7.Press MODE/ESC to return to the main menu.

SPOT – This function allows you to optimize the lamp without the use of an external DMX controller. In this mode, the device will not react to any control signal.

1.Access the main menu.

2.Tap the UP button until “SPEC” is displayed, press ENTER.

3.Tap the UP button until “DFSE” is displayed, press ENTER.

4.The display will show “ON/OFF.”

5.Press the UP button to display “ON” to activate this function, or “OFF” to deactivate this function.

6.Press ENTER to confirm.

7.Press MODE/ESC to return to the main menu.

DFSE - With this function you can restore the factory settings of the device. All settings will be set back to the default values. Any edited scenes will be lost. When restoring the factory settings the unit must be set to the address that the unit was in when you started editing. When you confirm this function, the fixture will begin to

reload the original factory settings.

1.Access the main menu.

2.Tap the UP button until “SPEC” is displayed, press ENTER.

3.Tap the UP button until “DFSE” is displayed, press ENTER.

4.The display will show “ON/OFF.”

5.Press the UP button to display “ON” to activate this function, or “OFF” to deactivate this function.

6.Press ENTER to confirm.

7.Press MODE/ESC to return to the main menu.

FEED - Use this function to activate the pan/tilt error correction. 1. Access the main menu.

Focus Spot 250R™