Indoor Pendant

Figure 3B

Installation of Optional In-Ceiling Mounting Kit

The indoor pendant model mounts on a Vicon mount or a 1.5-in. vertical pipe with an appropriate coupling. The pipe is a standard 1.5-in. NPT type and must be oriented vertically so the SurveyorVFT fixed camera dome can effectively hang from the pipe. Be sure the area around the selected location is clear of obstacles (such as steel beams, headers, pipes, electrical wiring, etc.) that would interfere with mounting. Video, sync, and power cables must be routed to the location.

1.Install the mount in accordance with the installation manual included with the mount or prepare the vertical 1.5-in. NPT pipe.

2.Feed all necessary cables through the back of the mount or out the end of the 1.5-in. NPT pipe, approximately 15 in. (381 mm) in length.

3.Lift the housing up to the mount or pipe and feed the cables through its top opening.

4.Place the housing onto the 1.5-in. pipe and screw clockwise, looking up at the housing. When it becomes snug, turn it an additional quarter-turn.

5.Verify that each cable drops from the pipe opening at least 15 in. (381 mm) in length.

6.Lift the camera mechanism up to the housing and attach the housing’s safety cord clip to the camera mechanism’s tab. Allow the SurveyorVFT mechanism to hang from the housing. Refer to Figure 2.

7.Route each cable from the inside top of the housing down over to its mating connector on the camera PC board. Add 1 in. (25 mm) of extra length to each cable for termination (if not previously terminated) and cut them. The approximate length of each cable should be 14 - 15 in. (356 - 381 mm).

Continue with the section on Cable Connections.

XX152-02-00 Rev 1004 SurveyorVFT Fixed Camera Dome

Installation • 7