Nikon XX152-02-00 specifications Disassembly, In-Ceiling Installation, Pendant Installation

Page 26

Disassembly

The SurveyorVFT Fixed Camera Dome can be easily disassembled by removing the camera mechanism from the housing or enclosure. A safety cord is always available to safely hang the camera mechanism while assembling or disassembling.

In-Ceiling Installation

1.Gently pull down on the lower dome’s outside edge, with two hands, until all molded tabs snap out of place.

2.Push in the tabs to release the camera mechanism from the enclosure. It will hang from the safety cord.

3.If it is necessary to completely remove the camera mechanism, disconnect the safety cord clip and all cables.

Pendant Installation

1.On outdoor version only, loosen the four (4) trim ring screws from the outdoor lower dome.

2.Gently pull down on the lower dome’s outside edge, with two hands, until all molded tabs snap out of place.

3.Push in the tabs on the housing until the camera mechanism is released.

4.Allow the SurveyorVFT to gently drop down until it is supported by the safety cord.

5.If it is necessary to completely remove the SurveyorVFT, remove all cable connections and disconnect the clip on the end of the safety cord from the tab on the enclosure.

16 Installation

XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome

Image 26
Contents XX152-02-00 Fixed Camera DomePage FCC Notice Safeguards Graphic Symbol ExplanationContents Quick Installation In-Ceiling No Access to CeilingIn-Ceiling Access to Ceiling Pendant Indoor Pendant Outdoor Page Introduction Models, Product Codes and DescriptionsInspection for Visible Damage InstallationUnpacking and Inspection Inspection for Concealed DamageSurveyorVFT Fixed Dome Components EnclosureUse of the Scribe Mounting the UnitIn-Ceiling Mounting Safety Cord Installation Mounting from Above the CeilingInstallation of Optional In-Ceiling Mounting Kit Optional Independent SupportIndoor Pendant Coaxial Video Cable Cable ConnectionsOutdoor Pendant Twisted-Pair Video CableCamera Power Connections Camera Synchronization DIP Switch SettingsAutoiris Adjustments Potentiometer/DIP Switch Location DIP Switch Settings In-Ceiling Final InstallationCamera/Lens Adjustments 5-50 mm Version Shown Camera Mounting Bracket Adjustment 2.6-6 mm Version Shown In-Ceiling Mount Final InstallationPendant Mount Dome Final Installation Outdoor Pendant Pendant Installation DisassemblyIn-Ceiling Installation Fuse Replacement MaintenanceCare and Cleaning of Lower Dome OperationShipping Instructions Reference Inch Pipe DesignationTwisted Pairs Wire DistancesTwisted-Pair Cable Belden1721X 24, Solid Polyethylene Bare Copper 100Technical Information Operating Temperature Dimensions In-CeilingWeight Storage Temperature RangeCamera Specifications Lens Specifications Model Focal Length Field-of-View Horizontal VerticalVicon Standard Equipment Warranty Brussels Office Corporate HeadquartersVicon Europe Headquarters Far East Office