Kodak DVC323 manual Camera connected

Problem	Cause	Solution
LED stays lit	Camera is not working	✔ Unplug the camera and then
	properly	plug it in again.
		✔ Reboot your computer with the
		camera plugged in.
“Unable to connect	Camera driver file is	✔ Unplug the camera and then
camera” message	missing or corrupted	plug it in again.
appears
		✔ Reboot your computer with the
		camera connected.
		✔ Un-install the DVC323
		software and then re-install it.
Still pictures are blurry	The subject is moving	✔ Rotate the focus wheel on the
	too fast for the shutter	camera until the image is sharp.
	speed, the camera is
		To see more detail, select High
	being moved while
		in the Quality field on the
	taking the picture, or the
		“Video Settings” window (see
	manual focus is set
		Chapter 4).
	incorrectly.
		✔ If in low light, place the camera
		in its base and on a stable
		surface. Start recording the
		video by using the mouse and
		the software application instead
		of pressing the shutter button
		on the camera. Make sure the
		subject is not moving rapidly.
		✔ If in normal or bright light,
		select Fast shutter speed on the
		“Video Settings” window. This
		will limit the shutter speed to a
		stop action setting to allow you
		to capture moving subjects
		with less motion blur, and
		allow hand-held use of the
		camera and use of the shutter
		button with much less camera
		shake.

5

Troubleshooting

5-5