Making connections
Installing the IEEE-1394 (FireWire) card in the host computer
Installing the Kodak Driver Software
Installing the IEEE-1394 (FireWire) cable
Follow the instructions for installing the IEEE-1394 (FireWire) card and the Kodak Driver Software before you plug the scanner into the host computer.
IMPORTANT: You must install the software on the host computer before you install the scanner.
An IEEE-1394 six-pin connector is provided on the rear panel of the scanner for IEEE-1394 (FireWire) connectivity.
1.Install the IEEE-1394 (FireWire) card in the host computer as described by the instructions included with the card.
WARNING: Installation of the connector in the wrong orientation will damage the scanner and IEEE-1394 FireWire card.
IMPORTANT: Use proper precautions to avoid static when you install the
IEEE-1394 (FireWire) card in your computer.
2.Power up the host computer after the IEEE-1394 (FireWire) card installation is complete.
1.Insert the Kodak i100 Series Installation CD in the CD-ROM drive. The installation program starts automatically.
2.Follow the on-screen instructions to install the TWAIN and ISIS drivers and the Kodak Scanner Validation Tool.
1.Attach the end of the IEEE-1394 (FireWire) cable to the IEEE-1394 port on the back of the scanner as shown.
2.Attach the other end of the IEEE-1394 (FireWire) cable to the host computer.
WARNING: Make sure that the position of the IEEE-1394 (FireWire) cable connector end correlates to the IEEE-1394 port configuration before you plug the cable in. Damage to the scanner will occur if the cable is attached in the wrong position.
IMPORTANT: The i100 Series Scanner should be the only item plugged into the IEEE-1394 (FireWire) card on the host computer.
