7.Inspect the rollers.
If the separator roller tires show signs of wear or damage, replace the tires or the separator module.
8.Insert the separator module and align the shaft ends.
9.Press until the separator module clicks into place.
10.Go to the next section to clean the feed module.
Cleaning the feed module 1. Push against the raised edge on the left side of the front drive roller cover to the side and pull the cover up and out to remove it.
Front roller cover
NOTE: You may need to lift the input tray slightly to remove the front roller cover.
2. Remove the feed module by pushing it to the right and lifting it out.
Feed module
23 |