Tasco 119215C instruction manual If you select the Photo mode icon #4 then press OK

Camera Setup (continued)

If you select the “Photo” mode icon (#4) then press “OK”:

•The LCD will blink the alternating indicators“1P”(single photo taken per trigger event) and “3P” (sequence of 3 photos taken per trigger event). Press “UP” or “DOWN” to select the setting you prefer, then press “OK” to confirm.

•Next, the LCD will display“LoHI”which sets the resolution for the still photos. “Lo” represents 3.0MP (the resolution of the sensor) and “HI” represents is 5.0MP (via software interpolation-the photo quality will be higher, but each file will use up more space on the SD card). Press “UP” or “DOWN” to select the resolution you prefer and press “OK” to confirm.

If you select the “Video” mode icon (#5) then press “OK”:

•The movie length is preset at 15 seconds and cannot be changed. There are no additional settings or options for Video Mode.

After pressing “OK” (when you finish selecting the settings for one/three photos and resolution if you chose “Photo” Mode), the “Delay Time” icon (#6) will blink next.

3. Setting the Delay Time

The Delay Time menu item allows you to set the interval that the camera will sleep before accepting a new PIR trigger, in minutes and seconds. This setting ranges from 1 second to 10 minutes. The default delay time is 10 S.

•While the Delay Time icon (#6) is blinking, press “OK” to confirm you want to set it.

•The LCD will display “0010”, with first the two digits indicating minutes and the last two digits indicating seconds.

•While the first two digits are blinking, press “UP” or “DOWN” to change the minutes value (Range from 00-60 min.). Press “OK” to confirm the minutes setting.

11