Troubleshooting / FAQ
5.Photos with streaked subject
a.In some cases with low lighting conditions and fast moving subjects, the 7MP resolution setting may not perform as well as the 5MP setting.
b.If you have multiple images where fast moving subjects produce streaks on the photo, try the 5MP setting instead.
6.Red , green or blue color cast
a.Under certain lighting conditions, the sensor can become confused resulting in poor color images.
b.If this is seen on a consistent basis, then the sensor may need servicing. Please contact Tasco customer service.
7.Short video clips—not recording to the length set
a.Check to make sure that the SD card is not full.
b.Make sure that the camera has good batteries in it. Near the end of the battery life, the camera may choose to record shorter video clips to conserve power.
Photos Do Not Capture Subject of Interest
1.Try to set your camera up in an area where there is not a heat source in the camera’s line of sight.
2.In some cases, setting the camera near water will make the camera take images with no subject in them. Try aiming the camera over ground.
3.Try to avoid setting the camera up on small trees that are prone to being moved by strong winds.
4.Remove any limbs which are right in front of the camera lens.
PIR Sensor LED Flashes/Doesn’t Flash
1.When the camera is in the “Setup” mode, the PIR Indicator LED on the front of the camera will flash when it senses motion. This is for setup purposes only and will help the user aim the camera.
2.During use, the LED will not flash when the camera takes an image. This is to help keep the camera hidden from game.
20