Recording
Date/Time Display — Clock Lithium Cell
The clock cell indicator 88:88 will flash for a few seconds in the viewfinder when you turn on the camcorder if the clock lithium cell has not been installed or needs to be replaced.
Clock Cell (+ Side Facing Up)
Clock Cell Holder
Install the Clock Lithium Cell
1.Make sure camcorder is turned off, and remove any power supply attached to the camcorder.
2.Pull out the clock cell holder.
3.Insert the clock cell with the “+” terminal facing up in the cell holder.
4.Slide the clock cell holder with the cell into the camcorder until it clicks into place.
Remove the Cell
1.Slide the cell holder out of the camcorder.
2.Remove the cell from the cell holder.
Cautions: Lithium cell battery. Replace only with
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell, and never short the + and – sides of the cell.
31