Remote Control
Install Remote’s Lithium Cell
The remote’s lithium cell is packed separately. Install it in the remote as follows:
1.Turn the remote over, insert a pencil or paper clip in the small hole, and slide the cell holder in the direction of the arrow to remove it.
2.Insert the cell in the cell holder so the positive (+) terminal faces up.
3.Replace the cell holder in remote by pressing in until it clicks into place.
Notes: Never place anything heavy on top of the remote control or lay it
Replace cell when camcorder fails to respond to remote.
Remove cell from remote if it will not be used for a month or more. This will prevent possible damage from cell leakage. If leakage occurs, wipe up liquid inside compartment and replace cell.
Cautions: Lithium cell must be disposed of properly. Never handle punctured or leaking cell. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212°F (100°C), or incinerate.
Never use metallic tweezers to hold the cells, and never short circuit the + and – sides of the cell.
15