Playback
Playback Operation
1.Set the CHANNEL 4CH/3CH switch on the RF output adapter to CHANNEL 4CH or 3CH.
2.Turn on the TV, and tune it to the same channel you selected with the RF output adapter’s CHANNEL switch.
3.Slide the POWER switch up to turn on the camcorder.
4.Press the VCR/CAM button to place the camcorder in the play mode. The green VCR indicator will light.
5.Press the PLAY button.
•During playback, use the playback features on page 37.
6.Press STOP on the camcorder when you are finished.
Viewing What the Camcorder Is Recording
1.Turn on the TV and tune it to channel
3 or 4. When the camcorder is used as a camera, turn the TV’s volume down to prevent a
2.Set the CHANNEL 4CH/3CH switch on the RF output adapter to the same channel you selected on the TV.
3.Slide the POWER switch up to turn on the camcorder. The red CAM indicator will light.
Note: When the camcorder is used as a camera, turn the TV’s volume down to prevent a
4.Press the REC START/STOP button (thumb trigger) to begin recording. You can watch what the camcorder is seeing (or recording) on the
TV screen.
Normal TV Viewing
For normal TV viewing, you may leave the RF output adapter hooked up to the
TV. Disconnect the adapter’s plug from the camcorder or turn off the camcorder.
Note: The remote will also operate the camcorder.
Press the DISPLAY button to have the camcorder’s displays appear on the TV screen. During tape copying, these displays will be recorded when they appear on the TV screen.
Note to Cable TV Installer
This reminder is provided to call your attention to Article
41