Elinchrom BX 500RI CE Statements, FCC Compliance and Advisory Statement, Disposal and recycling

Page 22

English

CE Statements

This device has been tested and found to comply with the requirements set

up in the council directive on the approximation of the law of member states relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and R&TTE Directive 99/5/EC

FCC Compliance and Advisory Statement

This device complies with Part 15 of the FCC rules. Operation is subject of the following two condi- tions: 1. this device may not cause harmful interference, and 2. this device must accept any interfer- ence received, including interferences that may cause undesired operation.

The equipment has been certified to comply with the limits for a Class B computing device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm- ful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television re- ception, which can be determined by switching the equipment off and on. The user can try to correct the interference by the following measures:

1.Reorient or relocate the receiving antenna

2.Increase the separation between the equipment and receiver

3.Connect the equipment to an outlet on a circuit different from that to which the receiver is con- nected.

4.Consult the dealer or an experienced radio/TV technician for help, changes or modification not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment.

Disposal and recycling

This device has been manufactured to the highest possible degree from materials which can be recycled or disposed of in a manner that is not environmentally damaging. The

device may be taken back after use to be recycled, provided that it is returned in a condi-

tion that is the result of normal use. Any components not reclaimed will be disposed of in an environmentally acceptable manner.

If you have any question on disposal, please contact your local office or your local­ ELINCHROM agent (check our website for a list of all ELINCRHOM agents worldwide).

21

Image 22
Contents Page Table of contents EnglishEnglish CE marking Declaration of conformityDisposal and recycling CE Statements for EL-SkyportFlash tubes and modelling lamps Safety NotePower cable TransportIncluded basic features Operating instructions Switch and fuse Mains supplyBefore you start Mains fuseControl panel Overview of controls Setup Visual-Flash-Control VFC mode Programmable features ResetHow to „Reset the BX-Ri Modelling lamp modesOpen flash «test» Digital multi-displaySychronisation socket Eye-Cell advanced photocell sensorAutomatic Eye-Cell Pre-Flash Setup c.0 Eye-CELL SetupUsing the Standard Photocell Mode Intelligent Photocell-SensorSetup Pre-Flash Timeframe only for advanced users Manual Eye-Cell Pre-Flash SetupPre-Flash Timeframe Setting t.X Charge Ready Beep Features Frequency Channel Settings EL- Skyport Transceiver For Wireless Triggering SetupGroup Settings Power Steps Per PushFlashtube replacementEnglish Error ManagementBX 500Ri Contents Hot-Shoe Connector with Screw-Lock FeaturesBattery Installation Operating InstructionsEL-Skyport Sync Speed & Standard Mode Frequency ChannelEL-Skyport Transmitter Speed RX Features Integrated Hot-Shoe Sync 2.5 mm SocketTroubleshooting EL-Skyport ModulesFCC Compliance and Advisory Statement CE StatementsDisposal and recycling