X10 Wireless Technology XX34A user manual

Sender: Make sure the sender mailbox server provider supports SMTP, and the mailbox should not enable SSL or TSL encryption.

Receiver: Here you can set four receivers. For receiver, there is no SMTP limitation.

SMTP Server: The sender’s SMTP Server.

SMTP Port: The sender’s SMTP Port, usually is 25, some SMTP servers have their own port, such as 587.

Need Authentication: If there is SMTP user & password, please select authentication.

SMTP User: Input correct SMTP User here. Some SMTP User is the sender’s full email address, such as test@qq.com, some are without suffix, only the username, such as test.

SMTP Password: Input correct SMTP password here.

NOTE: Click Submit first before choosing Test. You will see the test result after you click Test.

Figure 9.2

If it shows the following errors when you click Test. Please check that the information you filled in is correct and try again.

1)Cannot connect to the server.

2)Network Error. Please try later.

3)Server Error.

4)Incorrect user or password.

5)The sender is denied by the server. Maybe the server needs to authenticate the user, please check and try again.

6)The receiver is denied by the server. Maybe because of the anti-spam privacy of the server.

7)The message is denied by the server. Maybe because of the anti-spam privacy of the server.

8)The server does not support the authentication mode used by the device.

Report Internet IP by Mail: If selected, you will receive e-mails that contain the camera’s internet IP. When

camera is powered on or Internet IP changed, it will send the internet IP by e-mail. (For example: IPCAM's URL is http://121.213.109.69:1008).

44