1.4PC System Requirements
System configuration requirements:
CPU: 2.06 GHZ or above.
Memory: 256M or above.
Network Card: 10M or above.
Display Card: 64M or above memory.
Recommended Operating system: Windows XP, Windows Vista, Windows 7.
1.5Hardware Installation
Follow the steps below to set up your camera hardware.
1.Install the
2.Plug the power adaptor into the camera and into an AC outlet.
3.Plug the network cable into the camera and router/switch.
4.It takes approx 30 seconds to boot up the camera, then you will find the IP address from “IP Camera Tool” (Figure 2.1).
5.When the power is on and the network cable is connected, the green LED on the rear panel will stay on. The yellow LED will keep flashing, and the Indicator LED on the front of the camera will flash. (The indicator LED can be controlled by software).
Figure 1.4
1.6Software Installation
Attention: In order to make the installation correctly, we suggest that you turn off your Firewall and Antivirus software before installing ActiveX. Correct software installation is essential to the successful use of this product. Install the following software:
1.IP Camera Tool: Open the CD, double click “IPCamSetup.exe” then click next to complete the software installation. (Figure 1.6, 1.7, 1.8).
6