Uniden UDW-10003 user manual Unstable or Weak Signal, Weak signal and video performance

If…	Try..
None of the buttons on the
receiver respond when I	- Resetting the receiver.
press them.

Unstable or Weak Signal

If the video seems to lag and or the audio sounds weak, the camera and the receiver do not have a strong, clear signal between them. There are several causes for a weak signal:

Possible Cause	Solution
The camera might be too	- Adjust the antennas on the receiver and the camera. Often, changing
	the angle of the antenna can improve the signal strength.
far from the receiver.
	- Try moving the camera closer to the receiver.
The battery in the camera	Make sure the batteries in the camera and receiver are fully charged.
or receiver may be low.
	- Adjust the antennas on the receiver and the camera.
	- Remove as many obstacles from the signal path as possible,
	especially reinforced concrete walls and any large metal objecs that
	might reflect the signal.
There may be too many	- Avoid placing the camera and receiver where the signal path crosses
obstacles between the	a high-traffic area or body of water. For example, place the camera
camera and receiver.	on the same side of a hallway as the receiver or mount the camera at
	least 7 feet up.
	- Relocate the camera and receiver so that there is a clear line of sight
	between them.
	- Try moving the camera closer to the receiver.

Weak signal and video performance

The video performance is directly affected by the signal quality. As the signal weakens degrades, the amount of data transferred decreases, and the video frame rate goes down. The table below shows a breakdown of the performance you can expect at the different levels of signal quality.

18