Uniden UDW-10003 Using the camera mount, Mounting Camera screw brace Post Lock Screw holes

Using the camera mount

The camera has a built-in stand so you can place it on any flat surface. If you want to place your camera on a wall or a ceiling (or even if you just want to secure it to a flat surface), you can use the included camera mount.

(You might want to bring the receiver along when you mount the camera; it’s much easier to get the the camera into the right position when you have the display handy.)

1.Hold the base of the mount where you want to attach it, and mark the location of the screw holes.

2.Use the included screws and anchors to attach the base to the wall or ceiling.

3.Attach the camera to the mounting screw. Tighten it a few turns, then turn it to the direction you want.

	Tighten the brace against	1	Attach the camera
2			to the mounting
	the camera to		screw and turn it
	secure it		to the desired
	in place.		direction.

Mounting

Camera screw brace

Mounting

post

Post

lock

Screw holes

3

Loosen the wingnut to unlock the mounting post.

4	Adjust the post to
	the correct angle,

then tighten the wingnut to lock the post into place.

4.Tighten the camera brace up against the back of the camera to secure it into place.

5.Unlock the mounting post by turning the wingnut to the left a few turns.

6.Set the mounting post to the correct angle, then tighten the wingnut until the post is locked into place.