Chapter 3. Installing Camera & Network Setup
3.6. Ceiling Installation Example
-Attaching Template & Installing
Attach the enclosed template to the ceiling, then drill a hole in the ceiling according to the 88mm diameter hole marked on the template. Drop the camera cables down from the ceiling through the hole. Next, install the base,
Before installing the exposed bracket, open the hinged door at the bottom of the bracket as shown in the picture. Hold the knob on the hinged door to open it.
Template
Knob
-Connect Terminal Wires
Connect the cables to the terminal block on the hinged
door.
When connecting, please refer to 2.2 Camera Wiring Interface Board. Once the wiring is complete, close the hinged door.
Caution
•Do not connect the camera to a power outlet until the installation is complete. Supplying power while the installation is in progress may cause fire or damage the product.
-Configuring Camera DIP Switches
DIP switches for communication and ID protocols are located on the bottom of the camera. For more instructions, please refer to 3.2 DIP Switch Settings(Page 25).
Protocol (SW1,2,3), ID(SW4,5)
- Connecting Camera Sa
fety Cable and Attaching Camera
Carefully attach the camera to the mount following the alignment guide marks as shown in the picture. First, hook the camera's safety cable on the mount, and then attach the camera. The safety cable is coiled inside the base. As shown in the left hand picture, pull
out the safety cable from the base and then hook it to the mount.
Direction | Safety |
Cable | |
Guides |
|
| Direction |
| Guides |
AligntheDirection
Guides
※To attach the camera to the mount, refer to the alignment guide marks as shown in the picture.
Caution
•Make sure to hook the camera's safety cable to the mount before proceeding. Otherwise you may be exposed to serious injury caused by the camera falling.
NETWORK PTZ CAMERA 28 User Guide | NETWORK PTZ CAMERA 29 User Guide |