Caution
Do not install the product in a location where it may be exposed to extreme heat or cold.
Using the product in extremely hot (over 50°) or extremely cold (under
When using the product in hot areas, be sure to provide adequate ventilation for the product.
Do not drop the product, or subject it to strong shocks or vibration.
It may damage the product.
Do not touch the camera lens.
It is the most important component of your product. Avoid contaminating the lens with fingerprints or other pollutants.
Do not install the product in areas with flickering illumination.
Severe fluctuations in ambient luminance, such as flickering of old fluorescent lights, may cause the product to malfunction.
Never point the camera directly at the sun, or other powerful sources of light.
You may severely damage the charge-coupled device (CCD).
Do not disassemble the product or allow foreign objects to get into the product.
Product damage and/or fire may occur.
Detailed Warnings and Cautions
-Avoid operating the camera for long durations under high temperatures and in high humidity. Excessive heat can shorten the lifespan of the camera components.
Do not install or place the camera near any heat sources.
-Subjecting the dome cover to physical shock may damage the camera and cause water leakage into it.
-Do not place the camera facing direct sunlight or other intense light sources. Strong lights such as spotlights can cause
-Do not drop the camera or subject it to physical shock or vibration; this can cause serious damage to the camera.
-When installing the camera near a power line, make sure to keep at least 1 meter distance from the power line, or earth an additional metal pipe to separate the camera from the power source.
-This camera is for installation on a ceiling. Installing it on the ground or in a location that is not level may cause product malfunctions and shorten its lifespan.
-When installing it in an outdoor environment, use the outdoor housing.
-Avoid installing and operating the camera in the following places.
•Places where the temperature exceeds the camera’s recommended range.
(Indoors:
•Places where drastic temperature changes occur: e.g. Near an air conditioner.
•Places that are exposed to steam, oil, and flammable substances: e.g. Inside a kitchen.
•Places that are exposed to radioactivity,
•Places that are exposed to outdoor air contaminants: e.g. Dust and car exhaust.
•Places where there is high humidity.
•Places that are exposed to corrosive gas: e.g. Near the sea.
-Covers that are dusty or smeared decrease the picture and video quality. Clean the dome cover and camera lens on a regular basis.
-Remove the plastic wrap on the dome cover only after the camera installation is complete.
-This camera is not equipped with a power switch. Plug in the camera only after the installation is complete.
-The main unit has a large and a small door.
A large door has a
Caution
•Risk of Explosion if Battery is replaced by an Incorrect Type.
Dispose of Used Batteries According to the Instructions.(See 4 page)
NETWORK PTZ CAMERA 8 User Guide | NETWORK PTZ CAMERA 9 User Guide |