Chapter 4. Using Web Viewer
•Depending on the type of video, enter an address as from the examples in the following chart, and then click Play (P). (When using the default RTSP port number, 554, you may skip entering the port number.)
4.2.1.3 Motion Detection
Configure the camera’s Motion Detection operation.
The followings are examples of addresses for network streaming.
Address | Streaming Engine Settings |
|
|
rtsp://<IP>:<SERVICE PORT>/mpeg4unicast | For RTSP/TCP and RTP/UDP |
|
|
rtsp://<IP>:<SERVICE PORT>/mpeg4multicast | For RTSP/Multicast |
Notes <IP> : The current camera IP
<Service Port> : The number of the service port +1 that is selected at the Config Setup → Network menu.
ex) default port : 80 → <SERVICE PORT> : 81
※When using the default RTSP port number, 554, you may skip entering the port number.
Notes | : Selected Area, | : Other Areas. | |
|
|
|
|
|
|
|
|
Category |
|
| Description |
Enable |
| Check to enable Motion Detection. | |
|
|
| |
Sensitivity |
| Select a sensitivity level for motion detection according to the video display | |
| settings. 5 levels are available, and 5 is the most sensitive. | ||
|
| ||
|
|
|
|
Caution
•New settings are saved only if you click the button at the bottom of the screen.
Apply The button cancels new settings.
NETWORK PTZ CAMERA 48 User Guide | NETWORK PTZ CAMERA 49 User Guide |