Kramer Electronics PIP-300 Front Panel Picture in Picture Inserter Features, Feature Function

				Your Picture in Picture Inserter Machines
			Table 1: Front Panel Picture in Picture Inserter Features
		Feature		Function
1	POWER Switch			Illuminated switch for turning the unit ON or OFF
2	LCD Display			Displays data including the operation mode and the menu1 (2 lines at a time)
3	INPUTS2 Buttons			In the SINGLE mode: select the input to switch to the output
				In the PIP mode: select the input to appear in front
				Select an input for positioning and sizing
4	LAYER Button			When in the PIP mode, press to access the PIP Sizing and Position menu directly
5	FREEZE Button3			Press to freeze/unfreeze the output video image
6			￿	Moves the selected image to the left in the PIP mode4
				Moves to the previous character in the Labeling menu5
7	Buttons			Moves the selected image upwards in the PIP mode4
				Use to change the selected character in the Labeling menu5
			￿	Moves up one step (in the same level) in the OSD screen
				Increases the range by one step in the OSD screen
	Navigation
9				Moves the selected image downwards in the PIP mode4
8			￿	Moves the selected image to the right in the PIP mode4
				Moves to the next character in the Labeling menu5
			￿	Moves down one step (in the same level) in the OSD screen
				Decreases the range by one step in the OSD screen
				Use to change the selected character in the Labeling menu5
10	ENTER Button			Displays the main menu; moves to the next level; confirms a command
11	ESC Button			Exits the OSD Menu; reverts to the previous level; stops the execution of a command

Table 2: Rear Panel Picture in Picture Inserter Features

#		Feature	Function
12		CV BNC Connector	Connects to the composite video source
	1
13		Y BNC Connector
15	6	R-YBNC Connector
	INPUT		Connects to the component7 video source
14		B-YBNC Connector
16		Y/C 4p Connector	Connects to the s-Video source
17	OUTPUT	CV BNC Connector	Connects to the composite video acceptor
20		R-YBNC Connector
18		Y BNC Connector	Connects to the component7 video acceptor
19		B-YBNC Connector
21		Y/C 4p Connector	Connects to the s-Video acceptor
22	PROG. (IN)		Push in to upgrade to the latest Kramer firmware (see section 8)￿
23	RS-232 Port		Connects to the PC or other serial controller
24	Power Connector with FUSE		AC connector enabling power supply to the unit

1 See Figure 5

2 PIP-200xl has two input buttons and the PIP-300 has three input buttons 3 Illuminates when the image is frozen

4 See section 7￿ .1.1.1

5 See section 7￿ .1.4

6 The PIP-200xl has 2 sets of inputs; the PIP-300 has 3 sets of inputs. Each set includes CV; Y, B-Y, R-Y; and Y/C 7 For component video, connect all 3 connectors: Y, B-Y, R-Y (also known as Y, Pb/Cb, Pr/Cr or YUV)

7